Set the time on you Omni controller

Before you begin it is recommended that you verify the Omni Automation System is set to automatically update the date and time from the internet. (firmware R4.0.0 or above)
Follow the steps below at the Omni control panel.

Step 1: Use the right arrow to find the "config" icon, then press it.

Step 2: Press "date/time."

Step 3: Select "Network Time Options"

Step 4: Toggle the button to "ON," for

Automatically get date and time from internet.

Step 5: Toggle the button to "ON," Automatically adjust

for daylight saving time if your country follows daylight saving.

Step 6: Set the time zone slider for your location and last,

select the checkmark button to complete setting the time options.

At this point your date/time screen is expected to look like the following example with the two toggle switches at the top set to ON and the time zone set to your location.

Step 7: Reboot the Omni by pressing the power button (1) followed by Shut down (2). Restart by tapping the power button (3). Note: If this message does not appear after 2 minutes, flip the breaker. Wait 60 seconds to turn the breaker back on.

FAQ