How to control ORP Chlorination from the app
From the mobile app you can control the ORP Chlorination to automatically chlorinate a Body Of Water using chlorination. ORP Chlorination actively runs while the ORP level is below the set point and the filter pump is running. You can check on the state of the chlorinator as well as run diagnostics against a T-Cell which can be used to convert salt to chlorine.
To access the Chlorinator screen, select the Body Of Water tile and then the Chlorinator tile.
From the Body of Water screen you can see the current status of chlorination. A status of “On” indicates that chlorination is available to run.
When the Chlorinator is On it is available to chlorinate the water, if the filter pump is Off it will show as Temporally in Timed Mode.
When the Chlorinator is Off it is not available to chlorinate the water.
To have ORP Chlorination be available set the toggle to the right setting the Status to On. 
To have ORP Chlorination not be available set the toggle to the left setting the Status to Off.
Chlorinator Diagnostics are needed when you are experiencing problems with the chlorination. For example, alarms will be generated when the cell temperature or the salt readings in Parts Per Million (ppm) are outside of the expected range; either too low or too high. For an AquaRite, please use the LCD panel for the diagnostics.
Super Chlorination is run when the ORP Chlorination has not been keeping up with water sanitization needs.
Please be aware that while running Super Chlorinate that chlorination will take place regardless of the ORP reading.
To run Timed Chlorination in Super Chlorinate the Status must be set to On for the Super Chlorinate button to be available.
While Super Chlorinate is running the filter pump is ON for Super Chlorinate. Note that when Chlorinate is started the filter pump will be ON at High Speed.
Super Chlorinate runs as a timer set in 1 hour increments from 1 to 96 hours.
